The OZD 485 G12-1300 PRO Repeater is an electrical/optical interface converter made by Hirschmann. It is rated for 18 to 32 Volts DC of operating voltage, it has an IP 20 protection rating, and it weighs 215 grams. It supports both electrical full-duplex and half-duplex modes.
|Warranty:||1 year Networking-Hardware Warranty Included|
|Shipping:||Worldwide shipping via DHL, UPS, Fedex, and TNT|
|Repairs:||We offer repair service for the OZD 485 G12-1300 PRO.|
|Exchange:||Exchange credit for your defective unit available.|
The OZD 485 G12-1300 PRO Repeater from the FiberINTERFACES series is designed for the RS 485 field bus networks by Hirschmann. It has an RS 485 interface that can be used to construct a full-duplex transmission system. The OZD 485 G12-1300 PRO Repeater must be installed in an enclosure that has a durable and tool-removable cover. The approximate weight of the module is 215 grams. It provides DIN Rail mounting facilities. It can transmit all data rates. The OZD 485 G12-1300 PRO Repeater has a 3-pin screw terminal block and a 12-pin screw terminal block on the front of the module. The preferred operation mode of the module is the full-duplex mode, which uses a 4-wire interface. Channel 1 on this repeater module is a pure receiver, and channel 2 is a pure transmitter.
The OZD 485 G12-1300 PRO Repeater is a long-haul type of module with repeater functions. It uses a 7-pin terminal block for the signaling contact and a 3-pin terminal block for the voltage output. It also offers a 6-pin terminal block for port connections. The housing material is plastic. It supports redundancy functions such as a redundant power supply and a redundant ring. It is an electrically operated device with state-of-the-art technology for delivering high performance and reliable operation. The maximum power consumption rating of the OZD 485 G12-1300 PRO Repeater is 3.5 Watts. Its maximum current consumption rating is 200 milliamps. Make sure to use separate cable ducts for the power supply wires and bus line wires. A minimum separation of 15 centimeters must be maintained between the power switching elements and the module. This module only supports point-to-point connections. During installation, the electrical bus cables must be properly terminated at the start and end of the line.
0ZD 485 G12-1300 PRO
OZD A85 G12-1300 PRO
OZD 4b5 G12-1300 PRO
OZD 485 Gl2-1300 PRO
OZD 485 G12-l300 PRO
OZD 485 G12-13o0 PRO
OZD 485 G12-130o PRO
OZD 485 G12-1300 PR0
OZD 485 G12-1300 PROX