| Inches (H x D x W) | 1.75 x 16.0 x 17.5 |
| Flash memory | 128 MB |
| Switch Hibernation Mode (SHM) | places switch in very-low power mode during intervals of non-operation |
| Cisco AutoSecure | enables single-line Command-Line Interface (CLI) |
| Flexible NetFlow | next gen. for flow visibility technology |
| Maximum number of PoE+ (IEEE 802.3at) ports | - |
| 2960-X LAN Base Combinations | Yes |
| 2960-X LAN Base Combination | Yes |
| Unicast MAC addresses | 16,000 |
| Weighted Tail Drop (WTD) | Up to eight per port |
| Cross-stack EtherChannel | Cisco EtherChannel technology across diverse members of the stack |
| MAC-based VLAN assignment | validate on different VLANs |
| Product Number | WS-C2960XR-24TS-I |
| Operating temperature up to 5000 ft (1500 m) | -5ºC to 45ºC |
| Ethernet interfaces | 10BASE-T ports: RJ-45 connectors, 2-pair Category 3, 4, or 5 Unshielded Twisted-Pair (UTP) cabling |
| Voltage (auto ranging) | 90 VAC to 264 VAC |
| 0% traffic | 28.8 |
| DRAM | APM86392 600MHz dual core |
| IEEE 802.3az EEE (Energy Efficient Ethernet) | ports dynamically identify idle periods |
| Dynamic Host Configuration Protocol (DHCP) | a boot server simplifies switch deployment |
| Domain Name System as an Authoritative Source (DNS-AS) | network metadata held in a DNS server |
| Maximum number of PoE (IEEE 802.3af) ports | - |
| Stack bandwidth | 40G |
| 2960-S/SF LAN Base Combination | Yes |
| IPv4 unicast direct routes | 4000 |
| Flow-based rate limiting | scheduling |
| Flexlink | convergence time under 100 milliseconds |
| Cisco TrustSec | security and policy enforcement |
| Product Series | 2960XR |
| Centimeters (H x D x W) | 4.45 x 40.8 x 44.5 |
| Operating altitude | Up to 3000 m |
| Indicator LEDs | Per-port status: Link integrity, disabled, activity, speed, and full duplex |
| Current | 1A to 0.5A |
| 10% traffic | 36 |
| CPU | USB (Type-B), Ethernet (RJ-45) |
| Cisco EnergyWise | moderate the power consumed via PoE-powered endpoints |
| Stacking master configuration management | all switches are automatically upgraded to new software version |
| Cisco AutoConfig | hard-binding with the end device and the interface |
| Stack limit | 8 |
| Stack bandwidth | 80G |
| IPv4 unicast indirect routes | 1250 |
| 802.1p class of service (CoS) | congestion avoidance |
| IEEE 802.1s/w Rapid Spanning Tree Protocol (RSTP) | allow rapid spanning-tree convergence |
| Comprehensive 802.1X | control admission to the network |
| Manufacturer | Cisco |
| Pounds | 13 |
| Storage altitude | Up to 4000 m |
| Stacking interfaces | CAB-STK-E-0.5M stacking cable with a 0.5 m length |
| Frequency | 50 Hz to 60 Hz |
| 100% traffic | 36.2 |
| Console ports | USB (Type-A) for external flash storage |
| Autonegotiation | automatically chooses half- or full-duplex transmission mode |
| Cisco Smart Install | automated IOS Software image installation and configuration |
| Stack limit | 8 |
| IPv6 unicast direct routes | 4000 |
| Cross-stack QoS | up to 256 aggregate |
| Per-VLAN Rapid Spanning Tree (PVRST+) | reconvergence for per-VLAN spanning-tree basis |
| IPv6 First-Hop Security | enhances Layer-2 and Layer-3 network access |
| Feature Set | IP Lite |
| Kilograms | 5.9 |
| Operating relative humidity | 10% to 95% noncondensing |
| Console | CAB-CONSOLE-RJ45 Console cable 6 ft. with RJ-54 |
| Power rating (switch maximum consumption values) | 0.038 KVA |
| Weighted average | 36 |
| Storage interface | 10/100 Mbps Ethernet (RJ-45) |
| Dynamic Trunking Protocol (DTP) | dynamic trunk configuration via all switch ports |
| Cisco Auto SmartPorts | automated configuration of switch ports |
| IPv6 unicast indirect routes | 1250 |
| The Cisco committed information rate (CIR) | classification on a per-packet basis |
| Switch-port auto-recovery (Error Disable) | automatically tries to reactivate a link |
| Device Sensor and Device Classifier | enable seamless multipurpose device profiles |
| Uplink Interfaces | 4 SFP |
| Storage relative humidity | 10% to 95% noncondensing |
| Power | The internal PS is an auto-ranging unit & tolerates input voltages between 100 and 240V AC |
| Network management interface | 108 Gbps |
| Port Aggregation Protocol (PAgP) | automates the installation of Cisco Fast EtherChannel |
| Cisco Auto QoS | automatic configuration of QoS |
| IPv4 multicast routes and IGMP groups | 1000 |
| Power redundancy | an external RPS |
| Cisco Trust Anchor Technology | allows the switch to undergo IOS integrity checks |
| Available PoE Power | - |
| MTBF in hours | 557320 |
| Forwarding bandwidth | 216 Gbps |
| Link Aggregation Control Protocol (LACP) | Ethernet channeling |
| IPv6 multicast groups | 1000 |
| Cisco Threat Defense | Port Security Dynamic ARP Inspection & IP Source Guard |
| 10/100/1000 Ethernet interfaces (ports) | 24 |
| Switching bandwidth | 1023 |
| Automatic Media-Dependent Interface Crossover (MDIX) | adjusts transmit & receive pairs if incorrect cable type |
| IPv4 QoS ACEs | 500 |
| Private VLANs | controls traffic between hosts in a common segment |
| Stacking Bandwidth | 80 Gbps |
| Maximum active VLANs | 4096 |
| Unidirectional Link Detection Protocol (UDLD) | incorrect fiber-optic wiring detected and disabled |
| IPv6 QoS ACEs | 250 |
| Unicast Reverse Path Forwarding (uRPF) | solves problems caused by malformed or forged (spoofed) IP |
| Maximum Stack Limit | 8 |
| VLAN IDs available | 9198. bytes. |
| Switching Database Manager (SDM) | maximize memory allocation |
| IPv4 security ACEs | 1000 |
| Multidomain Authentication | enables an IP phone / PC to authenticate on the same switch port |
| Forwarding Rate | 71.4 Mpps |
| Maximum transmission unit (MTU)-L3 packet | 9216. bytes |
| Local Proxy Address Resolution Protocol (ARP) | minimize broadcasts and maximize bandwidth |
| IPv6 Security ACEs | 500 |
| Access Control Lists (ACLs) | security & QoS ACEs |
| Switching Bandwidth | 216 Gbps |
| Jumbo frame - Ethernet frame | 71.4 Mpps |
| VLAN1 minimization | allows VLAN1 to be disabled |
| Secure Shell (SSH) Protocol | allows for network security by encrypting administrator traffic |
| DRAM | 128 MB |
| Internet Group Management Protocol (IGMP) | fast client joins and departures of multicast streams |
| TACACS+ and RADIUS authentication | simplifies centralized control of the switch |
| Flash Memory | 13 |
| Multicast VLAN Registration (MVR) | isolate the streams from subscriber VLANs for bandwidth and security |
| MAC Address Notification | administrators informed of users added to or removed |
| Weight (Pounds) | 1.75 x 16.0 x 17.5 |
| Per-port broadcast | prevents faulty end stations |
| Multilevel security on console access | prevents unauthorized users from changing the switch configuration |
| Size (Inches) | IP Lite |
| Voice VLAN | simplifies telephony installations |
| Bridge protocol data unit (BPDU) Guard | avoid mistaken topology loops |
| Cisco VLAN Trunking Protocol (VTP) | supports dynamic VLANs |
| Spanning Tree Root Guard (STRG) | prevents uncontrolled edge devices from developing Spanning Tree Protocol root nodes. |
| Remote Switch Port Analyzer (RSPAN) | administrators remotely check ports via Layer 2 switch |
| IGMP filtering | facilitates multicast authentication |
| Layer 2 trace route | simplifies troubleshooting |
| Trivial File Transfer Protocol (TFTP) | lowers the price of administering software upgrades |
| Network Timing Protocol (NTP) | correct and reliable timestamp |
